Tidal does not playback 5.1 on Windows, even though it says Atmos, it doesn't work.What doesn't work, which also does not work on Sound Blaster Z DTS Connect where applicable: WARNING : DON'T LET THE WIRES TOUCH EACH OTHER, in my case, I just disconnected the Negative/Black wire. If you're unsure if 5.1 is working, I disconnected the L & R speaker wires and retest the audio. Then go back to Step 1 at the very beginning of this guide.Install the "AAF DCH Optimus Audio" from the "Realtek DCH Modded Audio Driver for Windows 10/11 - Including Realtek USB Audio Devices" thread. Go to the "Realtek Digital Output" properties panel and try again.If the "Audio Enhancements" section is missing from the "Realtek Digital Output" properties section try :.Go back to Step 4 in the original guide above and perform all steps again.From "FX Configurator", in the Endpoints selection, select " Realtek Digital Output (Realtek USB Audio) ".Go to the start menu and open "FX Configurator".If the name is different, note down the name, as you'll need it for steps below. Go to the Sound Control panel in Windows and select "Realtek Digital Output" as your default audio and run a speaker test, you should get audio from L & R speakers only.You might get an antivirus warning, you will need to decide on how you want to proceed. Locate the "APO Driver ", and install with only the following options.Install the standard Realtek USB audio drivers, in my case these were "Realtek USB Audio Driver V.2342 For Windows 10/11 64-bit." from the Asus support page for my motherboard.For this you will need the DriverStoreExplorer (by Remove any drivers whose "Provider" is "Realtek", "Dolby", "DTS", "Creative", "A-Volute", "AAF Optimus", etc in the "Sound, Video and Game Controllers", "Extensions", "Software Components" and "Audio Processing Objects" device categories. Uninstall AAF Audio using steps as detailed with the drivers using the standard instructions :īefore installing this modified driver, be sure to remove any and all residues from previous Realtek audio drivers or even if there are residues from previous versions of my mods, if they persist. Creative Sound Blaster Z with DTS Connect, working in 5.1, which I want to remove.OnBoard Audio installed with AAF DCH Optimus Audio driver installed, but not working in 5.1.
0 Comments
Leave a Reply. |